English
9English8
Storage
During the off-season or after extended periods of non-use, you may
choose to store your heater. To ensure long life of the product, it is
recommended to store your heater by following these instructions:
1. Unplug power cord and bundle loosely.
2. Thoroughly clean your heater (see HOW TO CLEAN for instruc-
tions).
3. Cover, or place back in retail carton if available. This will prevent
the unit from accumulating dust overtime.
4. Store unit in a cool and dry location.
Cleaning and Storage
How to Clean
Your heater has no user serviceable parts. Do not disassemble the
unit. This will void your warranty. If service is required, return your
heater to Vornado (see WARRANTY for instructions).
The motor is permanently lubricated and requires no oiling.
Because your heater moves a substantial amount of air, it will need
regular cleaning. To clean follow these simple instructions:
1. Unplug the unit.
Note: Do not use gasoline, thinners, solvents or other chemicals for
cleaning
.
2. Use the brush attachment on your household vacuum cleaner to
vacuum any accumulated dust off the Front Grill and Side Air In-
lets. Wipe down the entire surface with a soft cloth.
In smaller areas, you might prefer to set the unit in LOW mode. A vortex
beam of air will gently keep the air circulating in the room for even, uniform
heating.
In larger spaces, you might prefer to set the unit in HIGH mode. A vortex
beam of air will gently keep the air circulating in the room for even, uniform
heating.
To use the iControl as a personal fan, set the unit to FAN mode.
The iControl, like any other 1500-watt electric heater, draws up to 12.5 amps
of electric current. If using your iControl on HIGH setting causes your home
circuit breaker or fuse to trip, we offer the following suggestions:
Try turning off other electrical appliances that run on the same circuit as your
heater.
Run your heater in LOW mode.
Have your electrician add an additional circuit to your home’s
electrical system.
When the room temperature is higher than the set temperature it is normal
and correct to have little to no heat coming out of the iControl. When
the unit is first turned on there is a slight delay before heat will start to be
produced.
ALWAYS USE COMMON SENSE WHEN USING THIS AND/OR ANY
ELECTRICAL APPLIANCE.
Operating Tips
Troubleshooting
Unit is not plugged in. Plug Power Cord into electrical outlet.
Household circuit breaker / ground fault interrupter has tripped or blown a fuse. Reset circuit breaker /
ground fault interrupter, or replace fuse (See OPERATING TIPS).
The unit has overheated. Automatic Safety Shut-Off has initiated (See RESETTING YOUR VORNADO HEATER).
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Ensure unit is set to High Heat and thermostat is set to highest Temperature setting.
Close all doors and windows to trap heat.
Allow the unit to fully circulate the heat throughout the room, may take several minutes.
Unit fails to power on.
Unit is not producing
sufficent amount of heat.
Problem Possible Cause and Solution
(2 Seiten)
(11 Seiten)
(24 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern